Residential

Panel upgrades in Orleans and Ottawa

Electrical panel upgrades by a licensed and insured Master Electrician. The work starts with what your home draws now and what you plan to add.

  • Master Electrician
  • ESA compliant
  • Licensed and insured
  • BBB Accredited, A+ rated

Overview

Room for what your home needs to carry

A panel upgrade gives your home the capacity for the circuits it runs now and the ones you plan to add. It often comes up when a large new load is planned, such as EV charger installation in Ottawa, or when a renovation needs more circuits than the panel has room for. Building new instead? See new home wiring in Orleans and Ottawa. Request a quote and tell us what you want the panel to support.

Vincent Bourdeau standing beside his work van on a residential street
Vincent Bourdeau with the work van

What is included

What a panel upgrade covers

  1. 01

    Load calculation

    Rule 8-200 totals the basic load, the greater of electric heat and air conditioning, the range, a charger at 100% when no energy management system is used, and other loads at 25%.

  2. 02

    Panel replacement

    The old panel comes out, and the existing circuits are reconnected and labelled in the new one.

  3. 03

    Service size

    A 100 amp service did not cover ESA's worked example: that house calculated to 108.6 amps and needed a 125 amp minimum service. A 200 amp service is above that result. The calculation sets the size.

  4. 04

    Utility and ESA

    Hydro Ottawa and Hydro One disconnect the service before the meter socket is opened. The ESA notification is filed before the work starts. The disconnect request to the utility is part of the job.

Before you book

Good to know

Power off
The power to the house is off while the panel is changed over. We agree the timing with you first.
Plan ahead
If an EV charger, hot tub or addition is on the way, say so, and the panel is sized for it.
Full panel
No spare spaces is a common reason to look at an upgrade. The load calculation shows whether the service itself is also too small.

Questions

Panel upgrades questions

How do I know if I need a panel upgrade?

A Rule 8-200 load calculation shows whether the service can carry what you run now and what you plan to add. A panel with no spare breaker spaces is the other common reason. In ESA's example, the calculated load was 108.6 amps and the minimum service was 125 amps, which a 100 amp service does not meet.

Do I need a panel upgrade for an EV charger?

Not always. A 32 amp, 240 volt charger is 7,680 watts at 100% when no energy management system is used. If that pushes the calculated load over the existing service, the upgrade is planned with the charger. A 200 amp service covers the ESA example that a 100 amp service does not.

What is the difference between a 100 amp and a 200 amp service?

Both are 120/240 volt residential services. The load calculation has to fit the service rating. ESA's worked house, with a 32 amp charger, needed a 125 amp minimum, so it does not fit 100 amp. It does fit 200 amp. The bulletin's conductor example for that 125 amp result is No. 2 AWG copper or No. 1/0 AWG aluminum.

Do you deal with the utility?

Yes. Hydro Ottawa and Hydro One disconnect the service before work in the meter socket, and they reconnect it after the ESA has accepted the work. The disconnect request is part of the job. Tell us which utility is on the bill.

Who does the work?

Vincent Bourdeau, a licensed and insured Master Electrician. All work is ESA compliant.

How it works

From load calculation to ESA

  1. 01

    Request

    Tell us about your panel now and what you want to add.

  2. 02

    Load calculation

    We size the new panel and quote the work.

  3. 03

    Upgrade

    The utility disconnects the service. The panel is replaced and the circuits reconnected.

  4. 04

    ESA

    The notification is filed with the Electrical Safety Authority before the work starts.

Request a quote

Plan your panel upgrade

Tell us about your panel now and what you want it to carry.